Regular bathroom sinks and wash basins collect more dirt, grime, and grease than utility sinks. As a result, it will almost definitely necessitate additional upkeep. Drain traps, which must be unclogged to prevent water from flooding the sink and causing a foul stench, are commonly found in these sinks to prevent blockage and undue damage, hop over to here.

Unclogging a utility sink’s drain trap is a straightforward procedure. In fact, a wall mount utility sink makes this chore even easier because it provides the homeowner with greater space and freedom of movement while working. People often avoid this task and instead use a plunger to unclog their sinks. This is merely a band-aid remedy that may exacerbate the situation in the future. Because the plunger just pushes around the gunk in the pipes to allow water to get through, this is the case. It does not, however, completely remove the grease, grime, and filth. It is not necessary to hire a plumber to complete this work. To unclog a drain trap, all you need are slip joint pliers, hot water, a wire brush, and a bucket.

Place a pail beneath the sink before removing the trap to catch any particles that may fall as the trap is undone. With the slip join pliers, unbind the pipe’s slip nuts, then loosen them with your hands until they slide off. Clean the trap thoroughly with your wire brush before rinsing it with hot water. Repeat until you’re certain the trap is clean of debris and grime.

Then, using the pliers, re-attach the trap to the pipes and secure it in place, being careful not to over-tighten to avoid damaging the pipes. Allow the water to flow while the bucket remains under the sink to check for leaks. If there isn’t one, get the bucket and make sure you don’t spill the contents on the sink where you just fixed the drain trap.

Leave a Reply

Your email address will not be published. Required fields are marked *